FPV Set X Cross-air 2.4GHz 10dbi (MMCX)

Long-range FPV set for 2.4 GHz, which includes:
- 10 dBi crosshair panel antenna
- cloverleaf TX antenna with MMCX connector
- cloverleaf RX antenna

RHCP polarization.

The antennas are a paired set, matched to give you the best possible video transmission quality.

X_Crosshair

This is a 10 dBi directional antenna designed for long-range flights. Its main advantage is a very good axial ratio of 1.

The beamwidth is 70 degrees, but at shorter distances it can reach as much as 115-120 degrees.

Cross-air antenna specifications:
Frequency: 2.4 GHz
Gain: 10 dBi
Polarization: circular
Antenna type: directional
VSWR: <1.3
Beamwidth: 70 degrees (up to 120 degrees)
Polarization: RHCP
Connector: SMA or RP-SMA
Cable length: ~8 cm

Cloverleaf antennas:

3-lobe cloverleaf TX antenna.
This antenna can also be used as an RX antenna.

It is a circularly polarized antenna. Cloverleaf antennas are omnidirectional, with 360° coverage.

3-lobe cloverleaf antennas have a good axial ratio, so they reject oppositely polarized signals well.

We use high-quality materials to build our cloverleaf antennas. Solder joints are reinforced with a special low-loss adhesive. The antennas are also covered with a special rubber coating that protects and reinforces them. They are built on RG402 cable, which gives the structure sufficient rigidity.

Cloverleaf antenna specifications:
Frequency: 2.4 GHz
Gain: ~1.2 dBi
Cable length: ~8 cm (±1 cm)
Radiator: 1.2 mm copper-clad steel wire.
Radiator protection: orange rubber coating.
VSWR: below 1.4
Maximum power: 50 W
Connector: MMCX

4-lobe SPW cloverleaf RX antenna.

It is a circularly polarized antenna. Cloverleaf antennas are omnidirectional, with 360° coverage.

The 4-lobe cloverleaf has slightly better performance than the 3-lobe version, but because of its impedance it is not recommended as a TX antenna.

We use high-quality materials to build our cloverleaf antennas. Solder joints are reinforced with a special low-loss adhesive. The antennas are also covered with a special rubber coating that protects and reinforces them. They are built on RG402 cable, which gives the structure sufficient rigidity.

Cloverleaf antenna specifications:
Frequency: 2.4 GHz (specific frequency of your choice)
Gain: ~1.2 dBi
Cable length: ~10 cm (±1 cm)
Radiator: 1.2 mm copper-clad steel wire.
Radiator protection: orange rubber coating.
VSWR: below 1.4 over a limited range (due to the antenna's characteristics)
Maximum power: 50 W
Connector: SMA or RP-SMA

Made to order.
Lead time: ~5 working days.