Longrange Set X Cross-air 2.4GHz 10dbi (Toslon)

Antenna set for Toslon systems on 2.4 GHz, consisting of:
- crosshair panel antenna, 10 dBi
- cloverleaf TX antenna on a long (rigid) cable.

Antennas for Toslon TF500, TF520, TF640, TF740 and TF750 systems.
An ideal set for bait boats that will extend your range.



RHCP polarization.

The antennas are a paired set, matched to give you the best possible signal quality and long range.
Circularly polarized antennas are much more resistant to interference caused by signal reflections (multipath), which is especially noticeable over water.

XCrosshair

A directional antenna with 10 dBi gain, designed for long-range flights. Its main advantage is a very good axial ratio of 1.

The beamwidth is 70 degrees, but when flying at shorter distances it can reach as much as 115-120 degrees.

Cross-air antenna specifications:
Band: 2.4 GHz
Gain: 10 dBi
Polarization: circular
Antenna type: directional
VSWR: <1.3
Beamwidth: 70 degrees (up to 120 degrees)
Polarization: RHCP
Connector type: SMA or RP-SMA

Cloverleaf antennas:

3-lobe cloverleaf TX antenna.
It can also be used as an RX antenna.

It is a circularly polarized antenna. Cloverleaf antennas are omnidirectional, with 360-degree coverage.

3-lobe cloverleaf antennas have a good axial ratio, so the antenna rejects waves of the opposite polarization well.

We use high-quality materials to build our cloverleaf antennas. The solder joints are reinforced with a special low-loss adhesive compound. The antennas are also coated with a special rubber coating that protects and reinforces them. They are built on RG402 cable, which gives the design sufficient rigidity.

Cloverleaf antenna specifications:
Band: 2.4 GHz
Antenna gain: ~1.2 dBi
Cable length: ~20 cm (±1 cm)
Radiator: 1.2 mm copper-clad steel wire.
Radiator protection: special rubber coating.
VSWR: below 1.4
Maximum power: 50 W
Connector type: SMA or RP-SMA